HP 1660 Series - Define a Term for the State Trigger

Define a Term for the State Trigger
For the state analyzer to capture the data you want, you need to tell it what
to trigger on by defining a term. Trigger terms are used in the trigger
specification to tell the analyzer when to start recording data, what to store,
and when to stop.
1
Press the Trigger MENU key.
2 Highlight the base field under SCOUNT, and press the Select key.
Highlight
Hex in the pop-up menu, and press the Select key.
Hex is the default setting. Notice that there are other display options other
than hex.
3
Under SCOUNT, highlight the field to the right of b, enter 00, and
press the
Done key.
The "b" term is a variable to which you can assign a value.
Define a Term for the State Trigger
Result SCOUNT’s "b" term is assigned the value 00 (hex). The "b" term is a variable
that the analyzer will trigger on once you set up the trigger specification in
the next exercise.
The base field is used
to specify the type of
values entered.
A term is a variable that
stores a value. In this
exercise, you selected
Hex, and entered the
hex value 00 for the "b"
term.
Introduction to State Analysis
Define a Term for the State Trigger
3-8
Get other manuals https://www.bkmanuals.com