HP 5130 EI series User Manual

34
{ ATEQ1&W—Disables the modem from returning command responses and execution results,
and saves configuration.
To verify your configuration, enter AT&V to display the configuration results.
NOTE:
The configuration commands and output vary by modem. For more information, see the modem user
guide.
5. To ensure successful communication and to avoid data loss, verify that the modems are using a
transmission rate higher than the console port's baud rate.
6. Launch the terminal emulation program on the PC and create a connection using the telephone
number of the device-side modem.
Figure 15 through Figure 18 show the
configuration procedure in Windows XP HyperTerminal.
On Windows Server 2003, add the HyperTerminal program first, and then log in to and manage
the device as described in this document. On Windows Server 2008, Windows 7, Windows Vista,
or another operating system, obtain a third-party terminal control program first. Then, follow the
user guide or online help of that program to log in to the device.
Figure 15 Creating a connection

HP 5130 EI series Specifications

General

Layer	Layer 3
VLANs	4094
Multicast Protocols	IGMP, PIM
Operating Temperature	0°C to 45°C
Model	HP 5130 EI
Ports	24 or 48 10/100/1000 ports
Uplink Ports	4 x 1/10G SFP+
Stacking	Up to 9 switches
Power over Ethernet (PoE)	PoE+ (IEEE 802.3at) on PoE+ models (JG936A, JG937A)
Management	Web, CLI, SNMP
MAC Address Table Size	32, 000 entries
Routing Protocols	OSPF, RIP, BGP, static routing
Operating Humidity	10% to 90% (non-condensing)