7-49
Wireless Security Configuration
Configuring MAC Address Authentication
Verifying that the list was set on the WLAN. The following example
shows how to view the newly created list using the show wlan command.
ProCurve Access Point 530(radio1-wlan1)# show wlan 1
WLAN #1 on Radio 1
Description insecure
Status Disabled SSID PR3_WLAN
VLAN 1 - Untagged BSSID 00:14:C2:A7:11:A0
DTIM Period 2
Security Type no-security (No Sec.) Closed System Disabled
MAC Auth Mode local deny-list only MAC Auth List not set
Authentication open-system only WEP Key Type ascii
WEP Key 1 akshjsnensitk WEP Key Size 128bit
WEP Key 2 not set Default Key WEP Key 1
WEP Key 3 not set
WEP Key 4 not set
WPA or WPA2 WPA and WPA2 WPA Cipher TKIP only
WPA Pre-auth. Disabled WPA Key Format ascii
WPA ASCII Key abcdefghijklmnop
WPA Hex Key not set
Web Authentication
Status Disabled Retry Limit 3
Username/Password Login Enabled Guest Login Enabled
Redirect URL www.procurve.com
Default Login Page Enabled
Default Login Failed Page Enabled
Default Welcome Page Enabled
RADIUS
Failover To Local Disabled Retransmit Num. 3
Primary Auth local (built-in) server Prim. Auth Port n/a
Prim. Auth Key n/a - using local (built-in) RADIUS server
Primary RADIUS MAC Authentication
MAC Password n/a - using local RADIUS MAC Addr. Format n/a
Secondary Auth local (built-in) server Sec. Auth Port n/a
Sec. Auth Key n/a - using local (built-in) RADIUS server
Secondary RADIUS MAC Authentication
MAC Password n/a - using local RADIUS MAC Addr. Format n/a
Primary Acct not set Prim. Acct Port 1813
Prim. Acct Key not set
Secondary Acct not set Sec. Acct Port 1813
Sec. Acct Key not set
ProCurve Access Point 530(radio1-wlan1)