HP 5920 Series User Manual

90
mask: Specifies the mask in dotted decimal notation.
cost cost: Specifies the cost of the summary route, in the range of 1 to 16777214. Without this option, the
cost of Type-1 external routes defaults to the largest cost among routes that are summarized, and the cost
of Type-2 external routes defaults to the largest cost among routes that are summarized plus 1.
not-advertise: Disables advertising the summary route. Without this keyword, the command advertises
the route.
nssa-only: Limits the route advertisement to the NSSA area by setting the P-bit of Type-7 LSAs to 0. By
default, the P-bit of Type-7 LSAs is set to 1. If the ASBR is also an ABR and FULL state neighbors exist in
the backbone area, the P-bit of Type-7 LSAs originated by the ASBR is set to 0. This keyword applies to
the NSSA ASBR.
tag tag: Specifies a tag for marking the summary route, in the range of 0 to 4294967295. The default is
1. The tag can be used by a routing policy to control summary route advertisement.
Usage guidelines
With the asbr-summary command configured, an ASBR summarizes redistributed routes within the
specified address range into a single route and advertises the summary route in a Type-5 LSA to
neighbors. If the ASBR resides in an NSSA area, it advertises the summary route in a Type-7 LSA.
With the asbr-summary command configured, an NSSA ABR summarizes matching routes described by
Type-7 LSAs, and advertises the summary route to neighbors in Type-5 LSAs. This command does not take
effect on non NSSA ABRs.
To enable ASBR to advertise more-specific routes, issue the undo asbr-summary command.
Examples
# Summarize redistributed static routes into a single route, and specify a tag value of 2 and a cost of 100
for the summary route.
<Sysname> system-view
[Sysname] ip route-static 10.2.1.0 24 null 0
[Sysname] ip route-static 10.2.2.0 24 null 0
[Sysname] ospf 100
[Sysname-ospf-100] import-route static
[Sysname-ospf-100] asbr-summary 10.2.0.0 255.255.0.0 tag 2 cost 100
Related commands
display ospf asbr-summary
authentication-mode
Use authentication-mode to specify an authentication mode for the OSPF area.
Use undo authentication-mode to restore the default.
Syntax
For MD5/HMAC-MD5 authentication:
authentication-mode { hmac-md5 | md5 } key-id { cipher | plain } password
undo authentication-mode [ { hmac-md5 | md5 } key-id ]
For simple authentication:
authentication-mode simple { cipher | plain } password

HP 5920 Series Specifications

General

Brand	HP
Model	5920 Series
Category	Switch
Language	English