69
output-delay
Use output-delay to configure the rate at which an interface sends RIP packets.
Use undo output-delay to restore the default.
Syntax
output-delay time count count
undo output-delay
Default
An interface sends up to three RIP packets every 20 milliseconds.
Views
RIP view
Predefined user roles
network-admin
Parameters
time: Specifies the sending interval in the range of 10 to 100 milliseconds.
count: Specifies the maximum number of RIP packets sent at each interval, in the range of 1 to 30.
Examples
# Configure all interfaces running RIP process 1 to send up to 10 RIP packets every 60 milliseconds.
<Sysname> system-view
[Sysname] rip 1
[Sysname-rip-1] output-delay 60 count 10
peer
Use peer to specify a RIP neighbor in the NBMA network, where routing updates destined for the
neighbor are only unicasts and not multicast or broadcast.
Use undo peer to remove a RIP neighbor.
Syntax
peer ip-address
undo peer ip-address
Default
RIP does not unicast updates to any neighbor.
Views
RIP view
Predefined user roles
network-admin
Parameters
ip-address: Specifies the IP address of a RIP neighbor, in dotted decimal notation.
To Next Page
Loading...
Need help?
General
