507
Examples
# Configure the LSA retransmission interval on VLAN-interface 10 in instance 1 as 12 seconds.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospfv3 timer retransmit 12 instance 1
ospfv3 trans-delay
Use ospfv3 trans-delay to configure the transmission delay for an interface.
Use undo ospfv3 trans-delay to restore the default.
Syntax
ospfv3 trans-delay seconds [ instance instance-id ]
undo ospfv3 trans-delay [ instance instance-id ]
Default
The transmission delay is 1 second.
Views
Interface view
Predefined user roles
network-admin
Parameters
seconds: Specifies the transmission delay in the range of 1 to 3600 seconds.
instance-id: Specifies an instance by its ID in the range of 0 to 255. The default is 0.
Usage guidelines
Each LSA in the LSDB has an age that is incremented by 1 every second, but the age does not change
during transmission. Therefore, it is necessary to add a transmission delay into the age time, especially
for low-speed links.
Examples
# Configure the transmission delay as 3 seconds for VLAN-interface 10 in instance 1.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospfv3 trans-delay 3 instance 1
preference
Use preference to specify a preference for OSPFv3 routes.
Use undo preference to restore the default.
Syntax
preference [ ase ] [ route-policy route-policy-name ] preference
undo preference [ ase ]
To Next Page
Loading...
Need help?
General
