379
# In BGP IPv6 unicast address family view, specify the maximum number of routes that can be received
from peer 1::1 to 10000, and configure the router to tear down the session to the peer if the number is
exceeded.
<Sysname> system-view
[Sysname] bgp 109
[Sysname-bgp] address-family ipv6 unicast
[Sysname-bgp-ipv6] peer 1::1 route-limit 10000
peer route-policy
Use peer route-policy to apply a routing policy to routes incoming from or outgoing to a peer or peer
group.
Use undo peer route-policy to remove the configuration.
Syntax
In BGP IPv4 unicast address family view/BGP-VPN IPv4 unicast address family view/BGP VPNv4
address family view/BGP VPNv6 address family view:
peer { group-name | ip-address } route-policy route-policy-name { export | import }
undo peer { group-name | ip-address } route-policy { export | import }
In BGP-VPN VPNv4 address family view:
peer { group-name | ip-address } route-policy route-policy-name import
undo peer { group-name | ip-address } route-policy import
In BGP IPv6 unicast address family view:
peer { group-name | ip-address | ipv6-address } route-policy route-policy-name { export | import }
undo peer { group-name | ip-address | ipv6-address } route-policy { export | import }
In BGP-VPN IPv6 unicast address family view:
peer { group-name | ipv6-address } route-policy route-policy-name { export | import }
undo peer { group-name | ipv6-address } route-policy { ex
p
ort | import }
Default
No routing policy is applied to routes from/to the peer or peer group.
Views
BGP IPv4 unicast address family view, BGP-VPN IPv4 unicast address family view, BGP VPNv4 address
family view, BGP-VPN VPNv4 address family view, BGP IPv6 unicast address family view, BGP-VPN IPv6
unicast address family view, BGP VPNv6 address family view
Predefined user roles
network-admin
Parameters
group-name: Specifies a peer group by its name, a case-sensitive string of 1 to 47 characters. The peer
group must have been created.
ip-address: Specifies a peer by its IP address. The peer must have been created.
ipv6-address: Specifies a peer by its IPv6 address. The peer must have been created.
To Next Page
Loading...
Need help?
General
