HP 5920 Series

234
If only two routers exist on a broadcast network, configure the network type of attached interfaces as P2P
to avoid DIS election and CSNP flooding, saving network bandwidth and speeding up network
convergence.
Examples
# Configure the network type of VLAN-interface 10 as P2P.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] isis enable
[Sysname-Vlan-interface10] isis circuit-type p2p
isis cost
Use isis cost to set the IS-IS cost for an interface.
Use undo isis cost to remove the configuration.
Syntax
isis cost value [ level-1 | level-2 ]
undo isis cost [ level-1 | level-2 ]
Default
No IS-IS cost is configured for an interface.
Views
Interface view
Predefined user roles
network-admin
Parameters
value: Specifies an IS-IS cost in the range of 1 to 16777215.
level-1: Applies the cost to Level-1.
level-2: Applies the cost to Level-2.
Usage guidelines
If neither level-1 nor level-2 is included, the cost applies to both level-1 and level-2.
Examples
# Configure the Level-2 IS-IS cost as 5 for VLAN-interface 10.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] isis cost 5 level-2
Related commands
• auto-cost enable
• bandwidth-reference