57
display rip database
Use display rip database to display active routes for a RIP process. RIP advertises active routes in RIP
routing updates.
Syntax
display rip process-id database [ ip-address { mask-length | mask } ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
process-id: Specifies a RIP process by its ID in the range of 1 to 65535.
ip-address { mask-length | mask }: Displays active routes for the specified IP address. Without this
argument, the command displays all actives routes for a RIP process.
Examples
# Display active routes for RIP process 100.
<Sysname> display rip 100 database
1.0.0.0/8, auto-summary
1.1.1.0/24, cost 16, interface summary
1.1.1.0/24, cost 0, nexthop 1.1.1.1, RIP-interface
1.1.2.0/24, cost 0, imported
2.0.0.0/8, auto-summary
2.0.0.0/8, cost 1, nexthop 1.1.1.2
# Display active routes with destination IP address 1.1.1.0 and mask length 24 for RIP process 100.
<Sysname> display rip 100 database 1.1.1.0 24
1.1.1.0/24, cost 16, interface summary
1.1.1.0/24, cost 0, nexthop 1.1.1.1, RIP-interface
Table 20 Command output
Field Descri
tion
cost Cost of the route.
auto-summary Indicates that the route is a RIP automatic summary route.
interface summary Indicates that the route is a RIP interface summary route.
nexthop Address of the next hop.
RIP-interface Direct route on a RIP-enabled interface.
imported Indicates that the route is redistributed from another routing protocol.
display rip interface
Use display rip interface to display RIP interface information for a RIP process.
To Next Page
Loading...
Need help?
General
