HP 5920 Series

511
Examples
# Clear statistics for all OSPFv3 processes.
<Sysname> reset ospfv3 statistics
router-id
Use router-id to configure a router ID.
Use undo router-id to remove the configured router ID.
Syntax
router-id router-id
undo router-id
Default
No router ID is configured.
Views
OSPFv3 view
Predefined user roles
network-admin
Parameters
router-id: Specifies a router ID in IPv4 address format.
Usage guidelines
The router ID is the unique identifier for the device to run OSPFv3 in the AS. An OSPFv3 process cannot
run without a router ID.
Different processes must have different router IDs.
Examples
# Configure the router ID 10.1.1.3 for OSPFv3 process 1.
<Sysname> system-view
[Sysname] ospfv3 1
[Sysname-ospfv3-1] router-id 10.1.1.3
Related commands
ospfv3
snmp-agent trap enable ospfv3
Use snmp-agent trap enable ospfv3 to enable SNMP notifications for OSPFv3.
Use undo snmp-agent trap enable ospfv3 to disable the feature.
Syntax
snmp-agent trap enable ospfv3 [ grrestarter-status-change | grhelper-status-change | if-state-change
| if-cfg-error | if-bad-pkt | neighbor-state-change | nssatranslator-status-change | virtif-bad-pkt |
virtif-cfg-error | virtif-state-change | virtgrhelper-status-change | virtneighbor-state-change ] *