HP 5920 Series

557
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy-policy1-10] if-match as-path 1
[Sysname-route-policy-policy1-10] apply local-preference 130
apply mpls-label
Use apply mpls-label to set MPLS labels for routes.
Use undo apply mpls-label to restore the default.
Syntax
apply mpls-label
undo apply mpls-label
Default
No MPLS label is set for routes.
Views
Routing policy node view
Predefined user roles
network-admin
Usage guidelines
If this command fails to assign an MPLS label to a route, the route will not be advertised.
Examples
# Configure node 10 in permit mode for routing policy policy1 to set MPLS labels for routes.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy-policy1-10] apply mpls-label
apply origin
Use apply origin to set an ORIGIN attribute for BGP routes.
Use undo apply origin to restore the default.
Syntax
apply origin { egp as-number | igp | incomplete }
undo apply origin
Default
No ORIGIN attribute is set for BGP routes.
Views
Routing policy node view
Predefined user roles
network-admin