354
[Sysname-bgp] address-family ipv6 unicast
[Sysname-bgp-ipv6] peer test default-route-advertise
peer description
Use peer description to configure a description for a peer or peer group.
Use undo peer description to remove the description for a peer or peer group.
Syntax
peer { group-name | ip-address | ipv6-address } description description-text
undo peer { group-name | ip-address | ipv6-address } description
Default
No description information is configured for a peer or peer group.
Views
BGP view, BGP-VPN instance view
Predefined user roles
network-admin
Parameters
group-name: Specifies a peer group by its name, a case-sensitive string of 1 to 47 characters. The peer
group must have been created.
ip-address: Specifies a peer by its IP address. The peer must have been created.
ipv6-address: Specifies a peer by its IPv6 address. The peer must have been created.
description-text: Specifies a description for a peer or peer group, a case-sensitive string of 1 to 79
characters.
Examples
# In BGP view, configure a description for the peer group test as ISP1.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] peer test description ISP1
# In BGP-VPN instance view, configure a description for the peer group test as ISP1.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ip vpn-instance vpn1
[Sysname-bgp-vpn1] peer test description ISP1
peer ebgp-max-hop
Use peer ebgp-max-hop to enable BGP to establish an EBGP session to an indirectly-connected peer or
peer group and specify the maximum hop count.
Use undo peer ebgp-max-hop to restore the default.
Syntax
peer { group-name | ip-address | ipv6-address } ebgp-max-hop [ hop-count ]
To Next Page
Loading...
Need help?
General
