HP 5920 Series User Manual

62
[Sysname] route-policy frr permit node 10
[Sysname-route-policy-frr-10] if-match ip address prefix-list abc
[Sysname-route-policy-frr-10] apply fast-reroute backup-interface vlan-interface 1
backup-nexthop 193.1.1.8
[Sysname-route-policy-frr-10] quit
[Sysname] rip 100
[Sysname-rip-100] fast-reroute route-policy frr
filter-policy export
Use filter-policy export to configure RIP to filter redistributed routes.
Use undo filter-policy export to remove the filtering.
Syntax
filter-policy { acl-number | prefix-list prefix-list-name } export [ protocol [ process-id ] | interface-type
interface-number ]
undo filter-policy export [ protocol [ process-id ] | interface-type interface-number ]
Default
RIP does not filter redistributed routes.
Views
RIP view
Predefined user roles
network-admin
Parameters
acl-number: Specifies an ACL by its number in the range of 2000 to 3999 to filter redistributed routes.
prefix-list prefix-list-name: Specifies an IP prefix list by its name, a case-sensitive string of 1 to 63
characters, to filter redistributed routes.
protocol: Filters routes redistributed from the specified routing protocol, which can be bgp, direct, isis,
ospf, rip, or static.
process-id: Specifies the process ID of the specified routing protocol, in the range of 1 to 65535. Specify
a process ID when the routing protocol is rip, ospf, or isis. If no process ID is specified, the default
process ID is 1.
interface-type interface-number: Specifies an interface by its type and number.
Usage guidelines
If a protocol is specified, RIP filters only routes redistributed from the specified routing protocol. Otherwise,
RIP filters all redistributed routes.
If an interface is specified, RIP filters only routes advertised by the specified interface. Otherwise, RIP
filters routes advertised by all RIP interfaces.
To reference an advanced ACL (with a number from 3000 to 3999) in the command, configure the ACL
using one of the following methods:
• To deny/permit a route with the specified destination, use the rule [ rule-id ] { deny | permit } ip
source sour-addr sour-wildcard command.

HP 5920 Series Specifications

General

Brand	HP
Model	5920 Series
Category	Switch
Language	English