503
Default
No link-local address is specified for the neighbor interface.
Views
Interface view
Predefined user roles
network-admin
Parameters
ipv6-address: Specifies the link-local IPv6 address of the neighbor.
cost value: Specifies the cost of the neighbor, in the range of 1 to 65535.
dr-priority dr-priority: Specifies the DR priority of the neighbor, in the range of 0 to 255. The default is 1.
instance instance-id: Specifies an instance by its ID in the range of 0 to 255. The default is 0.
Usage guidelines
For NBMA and P2MP interfaces (only when in unicast mode), you must specify the link-local IPv6
addresses of their neighbors because these interfaces cannot find neighbors through broadcasting hello
packets. For NBMA interfaces, you can also specify DR priorities for their neighbors.
Examples
# On VLAN-interface 10, specify the link-local address of its neighbor as FE80::1111.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospfv3 peer fe80::1111
ospfv3 prefix-suppression
Use ospfv3 prefix-suppression to disable an OSPFv3 interface from advertising all its prefixes.
Use undo ospfv3 prefix-suppression to restore the default.
NOTE:
This command is available in Release 2311P04 and later versions.
Syntax
ospfv3 prefix-suppression [ disable ] [ instance instance-id ]
undo ospfv3 prefix-suppression [ instance instance-id ]
Default
Prefix suppression is disabled on an interface.
Views
Interface view
Predefined user roles
network-admin
Parameters
disable: Disables prefix suppression for an interface.
To Next Page
Loading...
Need help?
General
