514
[Sysname-ospfv3-100] snmp trap rate-limit interval 5 count 10
silent-interface(OSPFv3 view)
Use silent-interface to disable the specified interface from receiving and sending OSPFv3 packets.
Use undo silent-interface to restore the default.
Syntax
silent-interface { interface-type interface-number | all }
undo silent-interface { interface-type interface-number | all }
Default
An interface can receive and send OSPFv3 packets.
Views
OSPFv3 view
Predefined user roles
network-admin
Parameters
interface-type interface-number: Specifies an interface by its type and number.
all: Specifies all interfaces.
Usage guidelines
Multiple processes can disable the same interface from receiving and sending OSPFv3 packets. However,
the silent-interface command takes effect only on interfaces enabled with the current process.
Examples
# Disable VLAN-interface 10 from receiving and sending OSPFv3 packets in OSPFv3 processes 100 and
200.
<Sysname> system-view
[Sysname] ospfv3 100
[Sysname-ospfv3-100] router-id 10.100.1.9
[Sysname-ospfv3-100] silent-interface vlan-interface 10
[Sysname-ospfv3-100] quit
[Sysname] ospfv3 200
[Sysname-ospfv3-200] router-id 20.100.1.9
[Sysname-ospfv3-200] silent-interface vlan-interface 10
spf-schedule-interval
Use spf-schedule-interval to set the OSPFv3 SPF calculation interval.
Use undo spf-schedule-interval to restore the default.
Syntax
spf-schedule-interval maximum-interval [ minimum-interval [ incremental-interval ] ]
undo spf-schedule-interval
To Next Page
Loading...
Need help?
General
