552
Use undo apply comm-list to restore the default.
Syntax
apply comm-list { comm-list-number | comm-list-name } delete
undo apply comm-list
Default
No COMMUNITY attributes are deleted from BGP routes.
Views
Routing policy node view
Predefined user roles
network-admin
Parameters
comm-list-number: Specifies a basic community list by its number in the range of 1 to 99 or an advanced
community list by its number in the range of 100 to 199.
comm-list-name: Specifies a community list by its name, a case-sensitive string of 1 to 63 characters that
cannot contain only numbers.
Examples
# Configure node 10 in permit mode for routing policy policy1 to remove the COMMUNITY attributes
specified in community list 1 from BGP routes.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy-policy1-10] apply comm-list 1 delete
Related commands
ip community-list
apply community
Use apply community to set a specified COMMUNITY attribute for BGP routes.
Use undo apply community to remove the configuration.
Syntax
apply community { none | additive | { community-number&<1-32> | aa:nn&<1-32> | internet |
no-advertise | no-export | no-export-subconfed } * [ additive ] }
undo apply community [ none | additive | { community-number&<1-32> | aa:nn&<1-32> | internet |
no-advertise | no-export | no-export-subconfed } * [ additive ] ]
Default
No COMMUNITY attribute is set for BGP routes.
Views
Routing policy node view
Predefined user roles
network-admin
To Next Page
Loading...
Need help?
General
