11
# Display brief information about the active route permitted by the IP prefix list.
[Sysname] display ip routing-table prefix-list test
Routes Matched by Prefix list : test
Summary Count : 1
Destination/Mask Proto Pre Cost NextHop Interface
1.1.1.0/24 Direct 0 0 1.1.1.2 Vlan2
For command output, see Table 1.
# Display detailed information about all routes permitted by the IP prefix list.
[Sysname] display ip routing-table prefix-list test verbose
Routes Matched by Prefix list : test
Summary Count : 1
Destination: 1.1.1.0/24
Protocol: Direct Process ID: 0
SubProtID: 0x1 Age: 04h20m37s
Cost: 0 Preference: 0
Tag: 0 State: Active Adv
OrigTblID: 0x0 OrigVrf: default-vrf
TableID: 0x2 OrigAs: 0
NibID: 0x10000003 LastAs: 0
AttrID: 0xffffffff Neighbor: 0.0.0.0
Flags: 0x1008c OrigNextHop: 1.1.1.2
Label: NULL RealNextHop: 1.1.1.2
BkLabel: NULL BkNextHop: N/A
Tunnel ID: Invalid Interface: Vlan-interface2
BkTunnel ID: Invalid BkInterface: N/A
For command output, see Table 2.
display ip routing-table protocol
Use display ip routing-table protocol to display information about routes installed by a protocol.
Syntax
display ip routing-table [ vpn-instance vpn-instance-name ] protocol protocol [ inactive | verbose ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
vpn-instance vpn-instance-name: Specifies MPLS L3VPN instance by its name, a case-sensitive string of
1 to 31 characters. Without this option, the command displays routing information for the public network.
To Next Page
Loading...
Need help?
General
