HP 5920 Series User Manual

12
protocol: Specifies a routing protocol. It can be bgp, direct, isis, ospf, rip, or static.
inactive: Displays information about inactive routes. Without this keyword, the command displays
information about both active and inactive routes.
verbose: Displays detailed routing table information. Without this keyword, the command displays brief
routing information.
Examples
# Display brief information about direct routes.
<Sysname> display ip routing-table protocol direct
Summary Count : 13
Direct Routing Table Status : <Active>
Summary Count : 13
Destination/Mask Proto Pre Cost NextHop Interface
0.0.0.0/32 Direct 0 0 127.0.0.1 InLoop0
2.2.2.0/24 Direct 0 0 2.2.2.1 Vlan2
2.2.2.0/32 Direct 0 0 2.2.2.1 Vlan2
2.2.2.2/32 Direct 0 0 127.0.0.1 InLoop0
2.2.2.255/32 Direct 0 0 2.2.2.1 Vlan2
127.0.0.0/8 Direct 0 0 127.0.0.1 InLoop0
127.0.0.0/32 Direct 0 0 127.0.0.1 InLoop0
127.0.0.1/32 Direct 0 0 127.0.0.1 InLoop0
127.255.255.255/32 Direct 0 0 127.0.0.1 InLoop0
192.168.80.0/24 Direct 0 0 192.168.80.10 Vlan1
192.168.80.0/32 Direct 0 0 192.168.80.10 Vlan1
192.168.80.10/32 Direct 0 0 127.0.0.1 InLoop0
192.168.80.255/32 Direct 0 0 192.168.80.10 Vlan1
Direct Routing Table Status : <Inactive>
Summary Count : 0
# Display brief information about static routes.
<Sysname> display ip routing-table protocol static
Summary Count : 2
Static Routing Table Status : <Active>
Summary Count : 0
Static Routing Table Status : <Inactive>
Summary Count : 2
Destination/Mask Proto Pre Cost NextHop Interface
1.2.3.0/24 Static 60 0 1.2.4.5 Vlan10
3.0.0.0/8 Static 60 0 2.2.2.2 Vlan1
For command output, see Table 1.

HP 5920 Series Specifications

General

Model	HP 5920 Series
MAC address table size	32, 000 entries
Input voltage	100-240 VAC
IPv6 Support	Yes
Management	CLI, Web, SNMP
Jumbo frame support	Yes
Operating temperature	0°C to 45°C
Power Supply	Redundant (optional)
VLAN Support	Yes
Layer 3 Routing	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1X, RADIUS, TACACS+