151
Usage guidelines
When network changes are infrequent, LSAs are generated at the minimum-interval. If network changes
become frequent, the LSA generation interval is incremented by incremental-interval × 2
n-2
(n is the
number of generation times) for each generation until the maximum-interval is reached.
The minimum interval and the incremental interval cannot be greater than the maximum interval.
Examples
# Configure the maximum LSA generation interval as 2 seconds, minimum interval as 100 milliseconds
and incremental interval as 100 milliseconds.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] lsa-generation-interval 2 100 100
Related commands
lsa-arrival-interval
lsdb-overflow-limit
Use lsdb-overflow-limit to specify the upper limit of external LSAs in the LSDB.
Use undo lsdb-overflow-limit to restore the default.
Syntax
lsdb-overflow-limit number
undo lsdb-overflow-limit
Default
The number of external LSAs is not limited.
Views
OSPF view
Predefined user roles
network-admin
Parameters
number: Specifies the upper limit of external LSAs in the LSDB, in the range of 1 to 1000000.
Examples
# Specify the upper limit of external LSAs as 400000.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] lsdb-overflow-limit 400000
maximum load-balancing (OSPF view)
Use maximum load-balancing to specify the maximum number of equal-cost multi-path (ECMP) routes for
load balancing.
Use undo maximum load-balancing to restore the default.
To Next Page
Loading...
Need help?
General
