549
undo ipv6 policy-based-route
Default
No IPv6 is applied to an interface.
Views
Interface view
Predefined user roles
network-admin
Parameters
policy-name: Specifies a policy by its name, a case-sensitive string of 1 to 19 characters. The specified
policy must already exist.
Usage guidelines
You can apply only one policy to an interface. Before you apply a new policy, remove the current policy
from the interface.
Examples
# Apply policy aaa to VLAN-interface 2.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-Vlan2] interface vlan-interface 2
[Sysname-Vlan-interface2] ipv6 policy-based-route aaa
Related commands
• display ipv6 policy-based-route setup
• ipv6 policy-based-route (system view)
ipv6 policy-based-route (system view)
Use ipv6 policy-based-route to create an IPv6 policy or policy node and enter IPv6 policy node view. If
the specified IPv6 policy node already exists, the command directly places you into IPv6 policy node
view.
Use undo ipv6 policy-based-route to remove an IPv6 policy or IPv6 policy node.
Syntax
ipv6 policy-based-route policy-name [ deny | permit ] node node-number
undo ipv6 policy-based-route policy-name [ deny | node node-number | permit ]
Default
No IPv6 policy node is created.
Views
System view
Predefined user roles
network-admin
To Next Page
Loading...
Need help?
General
