493
lsa-generation-interval
Use lsa-generation-interval to configure the OSPFv3 LSA generation interval.
Use undo lsa-generation-interval to restore the default.
Syntax
lsa-generation-interval maximum-interval [ minimum-interval [ incremental-interval ] ]
undo lsa-generation-interval
Default
The maximum interval is 5 seconds, the minimum interval is 0 milliseconds, and the incremental interval
is 0 milliseconds.
Views
OSPFv3 view
Predefined user roles
network-admin
Parameters
maximum-interval: Specifies the maximum OSPFv3 LSA generation interval in the range of 1 to 60
seconds.
minimum-interval: Specifies the minimum OSPFv3 LSA generation interval in the range of 10 to 60000
milliseconds. The default is 0, which indicates that the minimum interval can be any value.
incremental-interval: Specifies the OSPFv3 LSA generation incremental interval in the range of 10 to
60000 milliseconds.
Usage guidelines
When network changes are infrequent, LSAs are generated at the minimum interval. If network changes
become frequent, the LSA generation interval is incremented by the incremental interval × 2
n-2
for each
generation until the maximum interval is reached. The value n is the number of generation times.
The minimum interval and the incremental interval cannot be greater than the maximum interval.
Examples
# Configure the maximum LSA generation interval as 2 seconds, minimum interval as 100 milliseconds,
and incremental interval as 100 milliseconds.
<Sysname> system-view
[Sysname] ospfv3 100
[Sysname-ospfv3-100] lsa-generation-interval 2 100 100
Related commands
lsa-arrival-interval
maximum load-balancing (OSPFv3 view)
Use maximum load-balancing to configure the maximum number of equal-cost multi-path (ECMP) routes
for load balancing.
Use undo maximum load-balancing to restore the default.
To Next Page
Loading...
Need help?
General
