HP 5920 Series

443
Examples
# Configure the tag for redistributed routes as 2.
<Sysname> system-view
[Sysname] ospfv3 1
[Sysname-ospfv3-1] default tag 2
Related commands
• default-route-advertise (OSPFv3 view)
• import-route
• route-tag (MPLS Command Reference)
default-cost (OSPFv3 area view)
Use default-cost to configure a cost for the default route advertised to the stub area or NSSA area.
Use undo default-cost to restore the default.
Syntax
default-cost cost
undo default-cost
Default
The cost is 1.
Views
OSPFv3 area view
Predefined user roles
network-admin
Parameters
cost: Specifies a cost for the default route advertised to the stub area or NSSA area, in the range of 0 to
167 77214.
Usage guidelines
This command takes effect only on the ABR of a stub area or the ABR/ASBR of an NSSA area.
Examples
# Configure Area 1 as a stub area, and specify the cost of the default route advertised to the stub area
as 60.
<Sysname> system-view
[Sysname] ospfv3 1
[Sysname-ospfv3-1] area 1
[Sysname-ospfv3-1-area-0.0.0.1] stub
[Sysname-ospfv3-1-area-0.0.0.1] default-cost 60
Related commands
• nssa (OSPFv3 area view)
• stub (OSPFv3 area view)