HP 5920 Series User Manual

58
Syntax
display rip process-id interface [ interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
process-id: Specifies a RIP process by its ID in the range of 1 to 65535.
interface-type interface-number: Specifies an interface by its type and number. If no interface is specified,
the command displays information about all RIP interfaces for the RIP process.
Examples
# Display information about all interfaces for RIP process 1.
<Sysname> display rip 1 interface
Interface: Vlan-interface2
Address/Mask: 1.1.1.1/24 Version: RIPv1
MetricIn: 0 MetricIn route policy: Not designated
MetricOut: 1 MetricOut route policy: Not designated
Split-horizon/Poison-reverse: On/Off Input/Output: On/On
Default route: Off
Current number of packets/Maximum number of packets: 0/2000
Table 21 Command output
Field Description
Interface Name of an interface running RIP.
Address/Mask IP address and mask of the interface.
Version RIP version running on the interface.
MetricIn Additional metric added to incoming routes.
MetricIn route policy
Name of the routing policy used to add an additional metric for
incoming routes. If no routing policy is used, the field displays Not
designated.
MetricOut Additional metric added to outgoing routes.
MetricOut route policy
Name of the routing policy used to add an additional routing metric
for outgoing routes. If no routing policy is used, the field displays Not
designated.
Split-horizon
Indicates whether split horizon is enabled:
• on—Enabled.
• off—Disabled.
Poison-reverse
Indicates whether poison reverse is enabled:
• on—Enabled.
• off—Disabled.

HP 5920 Series Specifications

General

Brand	HP
Model	5920 Series
Category	Switch
Language	English