114
IP Address Type State Cost Pri DR BDR
192.168.1.1 PTP P-2-P 1562 1 0.0.0.0 0.0.0.0
Area: 0.0.0.1
IP Address Type State Cost Pri DR BDR
172.16.0.1 Broadcast DR 1 1 172.16.0.1 0.0.0.0
Table 32 Command output
Field Descri
tion
Area Area ID of the interface.
IP address Interface IP address (regardless of whether TE is enabled or not).
Type Interface network type: PTP, PTMP, Broadcast, or NBMA.
State
Interface state:
• DOWN—No protocol traffic can be sent or received on the interface.
• Loopback—The interface is in loopback state and it cannot forward traffic.
• Waiting—The interface starts sending and receiving Hello packets and the
router is trying to determine the identity of the (Backup) designated router for
the network.
• P-2-P—The interface will send Hello packets at the interval of HelloInterval,
and try to establish an adjacency with the neighbor.
• DR—The router is the designated router on the network.
• BDR—The router is the backup designated router on the network.
• DROther—The router is a DROther router on the attached network.
Cost Interface cost.
Pri Router priority.
DR DR on the interface's network segment.
BDR BDR on the interface's network segment.
# Display detailed information about VLAN-interface 1.
<Sysname> display ospf interface Vlan-interface 1
OSPF Process 1 with Router ID 192.168.1.1
Interfaces
Interface: 172.16.0.1 (Vlan-interface1)
Cost: 1 State: DR Type: Broadcast MTU: 1500
Priority: 1
Designated router: 172.16.0.1
Backup designated router: 0.0.0.0
Timers: Hello 10, Dead 40, Poll 40, Retransmit 5, Transmit Delay 1
FRR backup: Enabled
Enabled by interface configuration (including secondary IP addresses)
MD5 authentication enabled.
The last key is 3.
To Next Page
Loading...
Need help?
General
