206
-----------------------------
Level-1 IPv4 Forwarding Table
-----------------------------
IPV4 Dest : 8.8.8.0/24 Int. Cost : 10 Ext. Cost : NULL
Admin Tag : - Src Count : 2 Flag : D/L/-
NextHop : Interface : ExitIndex :
Direct Vlan2 0x00000000
IPV4 Dest : 9.9.9.0/24 Int. Cost : 20 Ext. Cost : NULL
Admin Tag : - Src Count : 1 Flag : R/L/-
NextHop : Interface : ExitIndex :
8.8.8.5 Vlan2 0x00000003
Flags: D-Direct, R-Added to Rib, L-Advertised in LSPs, U-Up/Down Bit Set
Level-2 IPv4 Forwarding Table
-----------------------------
IPV4 Dest : 8.8.8.0/24 Int. Cost : 10 Ext. Cost : NULL
Admin Tag : - Src Count : 2 Flag : D/L/-
Flags: D-Direct, R-Added to Rib, L-Advertised in LSPs, U-Up/Down Bit Set
Table 64 Command output
Field Descri
tion
Route information for ISIS(1) Route information for IS-IS process 1.
ISIS(1) IPv4 Level-1 Forwarding Table IS-IS IPv4 routing information for Level-1.
ISIS(1) IPv4 Level-2 Forwarding Table IS-IS IPv4 routing information for Level-2.
IPV4 Dest IPv4 destination.
Int. Cost Internal cost.
Ext. Cost External cost.
Admin Tag Tag.
Src Count Count of advertising sources.
Flag
Route state flag:
• R—The route has been installed into the routing table.
• L—The route has been flooded in an LSP.
• U—Route leaking flag. Setting it to UP can prevent an LSP sent
from L2 to L1 from being sent back to L2.
Next Hop Next hop.
Interface Output interface.
ExitIndex Index of the output interface.
To Next Page
Loading...
Need help?
General
