HP 5920 Series - Page 41

28
Parameters
vpn-instance vpn-instance-name: Specifies an MPLS L3VPN instance by its name, a case-sensitive string
of 1 to 31 characters. Without this option, the command displays routing information for the public
network.
protocol: Specifies a routing protocol. It can be bgp4+, direct, isisv6, ospfv3, ripng, or static.
inactive: Displays information about inactive routes. Without this keyword, the command displays
information about both active and inactive routes.
verbose: Displays detailed routing table information. Without this keyword, the command displays brief
routing information.
Examples
# Display brief information about direct routes.
<Sysname> display ipv6 routing-table protocol direct
Summary Count : 3
Direct Routing Table Status : <Active>
Summary Count : 3
Destination: ::1/128 Protocol : Direct
NextHop : ::1 Preference: 0
Interface : InLoop0 Cost : 0
Destination: FE80::/10 Protocol : Direct
NextHop : :: Preference: 0
Interface : NULL0 Cost : 0
Destination: FF00::/8 Protocol : Direct
NextHop : :: Preference: 0
Interface : NULL0 Cost : 0
Direct Routing Table Status : <Inactive>
Summary Count : 0
# Display brief information about static routes.
<Sysname> display ipv6 routing-table protocol static
Summary Count : 3
Static Routing table Status : <Active>
Summary Count : 3
Destination: 2::2/128 Protocol : Static
NextHop : fe80::2 Preference: 60
Interface : Vlan2 Cost : 0
Destination: 2::2/128 Protocol : Static
NextHop : fe80::3 Preference: 60
Interface : Vlan2 Cost : 0