HP 8753E - Creatingaslopinglimitline; Example Flat Limit Lines

Figure 2-42. Example Flat Limit Lines
Creating a Sloping Limit Line
This example procedure shows you how to make limits that test the shape factor of a SAW
titer. The following limits are set:
1.
2.
Frequency Bange
.................................................................
Power Range
123MHzto125MHz..
........................................................
-65dBto-26dB
144 MHz to 146 MHz
..........................................................
-26 dB to -65 dEI
To access the limits menu and activate the limit lines, press:
To establish the start frequency and limits for a sloping limit line that tests the low side of
the filter, press:
Making Measurements 249