HP 8753E - Setting the Measurement; Setting the Source Power; Step 3. Perform and Apply the Appropriate Error-Correction

To Next Page

To Previous Page

‘lb

set the span to 30 MHz, press:

&g(ziJm

Note

You could also press the

and

&TJ

keys and enter the frequency range

limits as start frequency and stop frequency values

Setting the Source Power.

change the power level to -5

dRm,

press:

Note

You could also press

~~~~.~~~~~~~~

~~~~~~:~,~~~~~

and select

one

of the

power ranges to keep the power setting within the

deGned

range.

Setting the Measurement.

‘Ib

change the number of measurement data points to 101, press:

7. To select the transmission measurement, press:

view the data trace, press:

Step 3.

Perform

and apply the appropriate error-correction.

9. Refer to the

“OpUmizing

Measurement Results” Chapter for procedures on correcting

measurement errors.

10. To save the instrument state and error-correction in the analyzer internal memory, press:

24 Making Measurements

Other manuals for HP 8753E