Using the Display Functions
To
View Both Primary Measurement Channels
In some cases, you may want to view more than one measured parameter at a time.
Simultaneous gain and phase measurements for example, are useful in evaluating stability in
negative feedback amplifiers. You can easily make such measurements using the dual channel
display.
1. To see channels 1 and 2 in the same grid, press:
”
,.:s’<$$:.<
2*
‘lb
view the measurements on separate graticules, press: Set
~~~~~~~~‘~~~~~
to
2X.
The
analyzer
shows
channel
1
on
the
upper
half
of
the
display
an~~~~~~~~n
the
lower
half
of the display. The analyzer also defaults to measuring
Sll
on channel 1 and &I on channel
2.
~000027
Figure 2-3. Example
Dua.l
Channel With Split Display On
2-6
Making Measurements
To Next Page
Loading...
