Start of Sequence
FILE NAME
DTCLOOP]
PLOT NAME
PLCLOOPI
SINGLE
SAVE FILE 0
PLOT
DECR LOOP COUNTER
IF LOOP COUNTER 0 THEN DO
SEQUENCE 2
Sequence 1 initializes the loop counter and calls sequence 2. Sequence 2 repeats until the loop
counter reaches 0. It takes a single sweep, saves the data
file
and plots the display.
n
The data
file
names generated by this sequence will be:
DT00007.Dl
through
DT000001.Dl
n
The plot
llle
names generated by this sequence will be:
PL00007.FP
through
PL00001.FP
‘lb nm the sequence, press:
Limit
Test
Example Sequence
This measurement example shows you how to create a sequence that will branch the sequence
according to the outcome of a limit test. Refer to
“‘lksting
a Device with Limit Lines,” located
earlier in this Chapter, for a procedure that shows you how to create a limit test.
For this example, you must have already saved the following in register 1:
w
device measurement parameters
n
a series of active (visible) limit lines
n
an active limit test
1. To create a sequence that will recall the desired instrument state, perform a limit test, and
branch to another sequence position based on the outcome of that limit test, press:
Making Measurements
2-79
To Next Page
Loading...
