Analyzer Display
o-
6
o--
5
DATA DISPLAY
it
AREA
a
1
D
2
pg64d
Figure 1-2. Analyzer Display (Single Channel, Cartesian Format)
The analyzer display shows various measurement information:
n
The grid where the analyzer plots the measurement data.
n
The currently selected measurement parameters.
n
The measurement data traces.
Figure
l-2
illustrates the locations of the different information labels described below.
In addition to the full-screen display shown in Figure l-2, multi-graticule and multi-channel
displays are available, as described in “Using the Four-Parameter Display Mode” in Chapter 2,
“Making Measurements.
*
Several display formats are available for different measurements, as described under
“(jj)”
in Chapter 9, “Key
Definitions”
1.
Stimulus Start Value. This
value could be any one of the following:
n
The start frequency of the source in frequency domain measurements.
H
The start time in CW mode (0 seconds) or time domain measurements
n
The lower power value in power sweep.
When the stimulus is in center/span mode, the center stimulus value is shown in this
space. The color of the
stimuhis
display reflects the current active channel.
HP
6753E
Description and Options
l-7
To Next Page
Loading...
