group delay, 7-15
harmonics (option
002),
7-11
impedance,
7-l
1
magnitude, 7-13
measurement port, 7-2
noise level, 7-11
option 001, 7-17
output power, 7-10
phase, 7-13, 7-14
remote programming, 7-17
spectral purity characteristics, 7-10
spurious signals, 7-10
type-N test ports, 7-4
uncorrected, 7-3
uncorrected test port, 7-3
specify
class menu, 6-88
offset menus, 6-87
spectral purity characteristics, 7-10
spectrum of RF&C and IF signals present in
a conversion loss measurement, 3-7
speed increased, 5-50
spurious
signals
specifications, 7-10
SRl
(complete service request capabilities),
11-19
SRQ (service request) control
line,
11-18
S (service request asserted by the analyzer),
11-20
standard connections for
fuII
two port error-correction, 5-21
one port reflection error-correction, 5-19
receiver calibration, 5-12
response and isolation error-correction
for& reflection measurements, 5-15
response and isolation error-correction
for& transmission measurements, 5-17
response error-correction for reflection
measurement, 5-10
response error-correction for transmission
measurements,
5-l
1
standard
dehnitions
entering, 5-27
. .
exammmg
, 5-27
modifying, 5-27
standards
calibration, 5-6
defining menus, 6-85
start frequency set with markers, 2-27
f-J.m!
a plot, 4-16
a print, 4-6
start values possible,
l-7
statistics calculation, 2-36
status indicators, 1
l-20
HP-IB,
6-l
12
* status notation,
l-9
status notations,
l-8
step attenuator, 6-2
switch protection, 6-20
step keys, 6-10
stepped
list
frequency sweep, 6-23
steps of making a measurement, 2-3
stimulus
function block,
l-4
state, 5-5
stimulus function, 6-12-27
stimulus function block location,
l-4
stimulus menu, 6-13
stop frequency
setting with markers, 2-27
stopping
a
print or plot, 4-30
a sequencing, 2-70
stop values possible,
l-8
storage
locations, 4-33
mediums, 4-33
storage conditions, 7-20
storing
a sequence on a disk, 2-74
to external disk, 11-5
to internal disk, 11-5
to internal memory, 11-5
storing data
methods of, 12-1
structure of HP-IB bus, 11-17
subtract memory trace from the measurement
data trace, 2-8
support and service options, 1-14
sweep
definition of, 6-5
how to set auto sweep time, 5-51
how to set chop sweep, 5-54
sweep modes
alternate, 6-27, 6-108
chop, 6-27, 6-108
sweep speed
increase, 5-50
increasing, 5-50
sweep time
auto, 6-17
manual, 6-17
minimum, 6-17
sweep type
how to set, 5-53
sweep types, 6-22
CW time, 6-27
Index-23
To Next Page
Loading...
