HP 8753E - Creating a Sequence

Creating a Sequence
1. ‘lb enter the sequence creation mode, press:
As shown in F’igure 2-55, a list of instructions appear on the analyzer display to help you
create or edit a sequence.
Only sequence 6 IS SoYed when ,n*trument IS turned off
seiect 0 softkey to start nmdifylng 0 sequence -
pg697d
Figure 2-55. ‘l&t Sequencing Help Instructions
2. ‘RI select a sequence position in which to store your sequence, press:
This choice selects sequence position #l. The default title is SEQl for this sequence.
Refer to “Changing the Sequence Title,” (located later in this Chapter) for information on
how to modify a sequence title.
Making Measurements 2-69