HP 8753E - Searching for a Lhrget Amplitude

Searching for a ‘beget Amplitude
1. Press (@i&X$ ~~~~~~~~ to access the marker search menu.
/. ..d;:.:<IR;~ .z “F: :<:.
2* Press ~~~~,~~~~~ to move the active marker to the target point on the measurement
trace.
3. If you want to change the target amplitude value (default is -3 dB), press ~~~~~ and
enter the new value from the front panel keypad.
4. If you want to search for multiple responses at the target amplitude value, press
.;“:.:~,. .:.: .v,..:.: / .y. ,, ..::.:......:>:;-
,.,:; ,.. .:: .’ :...:,v ,:::....:..:..: ; .; ;. :.: : ‘: ”
~~~;;~~ ad ‘~~~~:~~~6~.~.
:.. . ..+<. :... .A;.. . ..T ::... .:..::
:....:..:i:::.:~:.......~..
ii
:i:.: s
. . . . . . :.:.
I@ dB/
REF -45 dB
I -2s 01 dS
WI
t
18 dB/
REF -45 d*
1 -2s 087 dS
Figure 2-26.
Example of Searching for a Beget Amplitude Using a Marker
234 Making Measurements