Formatting a Disk
2. Choose the type of format you want:
Solving Problems with Saving or Recalling Files
If you encounter a problem when you are storing
flies
to disk, or the analyzer internal memory,
check the following list for possible causes:
w
Look in the analyzer display message area. The analyzer may show a message that will
identify the problem. Refer to the “Error Messages” chapter if you view a message.
n
Make sure that you are
NCYI
using a single-sided floppy disk in the analyzer disk drive.
n Make sure that you are using a formatted disk.
n Make sure that the disk has not been formatted with the LIF-HFS (hierarchical
ille
system)
extensions as the analyzer does not support this format.
If
Yim
Are Using an External Disk Drive
n Make sure that the analyzer is in system controller mode, by pressing
m
. . . . . . . . . . . . . . . . . . .
I......
..%...
~~~~~~~~~~~~
. . . . . . . .
..w.u............_.
<T
.:..
>
>::..
2
. . . . .
..>.......
>
..::......>:::..
*..::.:.:--i;;;;.;;;-;
ii........... . . . . .
~.w>..:..:-
n Make sure that you have connected the disk drive to ac power, switched on the power, and
connected an HP-IB cable between the disk drive and the analyzer.
w
Make sure that the analyzer recognizes the disk drive’s HP-IB address, as explained earlier in
this chapter.
n Make sure that the analyzer recognizes the disk (drive) unit that you selected (0 or 1).
n If the external disk is a hard disk, make sure that the disk volume number is set correctly.
n If the disk drive is an older HP 9122, it may not recognize the newer high density disks.
w
Substitute the HP-IB cable.
n
Substitute the disk drive.
Printing, Plotting, and Saving Measurement Results
443
To Next Page
Loading...
