HP 8753E - If You Are Plotting to a Pen Plotter

If Yim Are Plotting to a Pen Plotter
and then @ii. &g. Mti,
.:. . . . . . . . . . . i.. ., ;::.::<<<<..<...:
2. Configure the analyzer for one of the following plotter interfaces:
‘:,.,‘,:::; .c<: :.:..
::<>+,;;z;.;.. ., I:” ,.
n Choose ~~~~~~~~~~~~~~. if your plotter has an HP-IB interface, and then conllgure the
;.i......................~.,.;~;...;~;~:.~ ..,. ;::::<L.: .: .:.:::.>..
plot function as follows:
a. Enter the HP-IB address of the plotter (default is 05), followed by (ZJ
. Choose ~~~ if your plotter has a pwallel (centronics) titefiace, and then co~we
. . . . . . . . . . . . . .. . . . . . . . . . . . ..~~~...... . . . . . . . .,., :;.<<< . . . .
the plot function as follows:
:,::.:::y i ..::. ,,;,~,~,~, ..I. :...:.:.
0 Press (Local) and then select the parallel port interface function by pressing ~9%J&l&&:
i .:: ;: ii/ .A...
until the correct function appears.
. If you choose ~~~~~~~~~.
,
the parallel port is dedicated for normal copy
device use (printers or plotters).
. If you choose ,~~~~i~~~~~~~.“, the parallel port is dedicated for generaJ. purpose
1:. ;A;;,. . . . ss .::.. .:::.:.
I/O, and cannot be used for printing or plotting.
z,:.:. ,._: .,.,. :.:.:~.:~.:.:.:.:.:.:“:.::.:.:.:.:.:.: . . . .
w Choose .@&&@j if your plotter ha a s&d (ES-232) interface, ad then con-e the plot
.i.;;;;..-......... :... .::..:. .::
function as follows:
a. fiess ~~~~~~~~~~~: and enter the plotter’s baud rate, followed by ml.
;;,.~./............... . . . . . . . . ss -.............. ._.. .w::::.: . . . . . . ~;..;............;.........~:.~::.::.... . . . ..:;;;;.
b. To select the transmission control method that is compatible with your plotter, press
~~~~~~~ (wa,nsl-& control - ha,n&h&ng protocol) mtiI the correct method
appears.
q If you choose ~~~~~~~~I the handsh*e method sows the pIotter to controI the
:.<:.; . . . . . . . .. . . . . . /.li >A..,,’
data exchange by transmitting control characters to the network analyzer.
q If you choose .~~~~~~~, the handshake method allows the plotter to control the data
exchange by setting the electrical voltage on one line of the RS-232 serial cable.
Note
..:.::: :./;;;; . . . . .,
:: /::. : >:::,:.,.: . . . .
../
Because the +@Q&IX@ handshake takes place in the hardware rather than the
llrmware or software, it is the fastest transmission control method.
4-10 Printing, Plotting, and Saving Measurement Results