HP 8753E - Measuring Insertion Phase Response

4. Reconnect your test device.
5.
lb better view the measurement trace, press:
. . . ,.
,._.,..,.,./. . . . . .
/ . . . . .
cm) &q?$f,, ,$&gg#
6. To locate the maximum amplitude of the device response, as shown in Figure 2-30, press:
_ i _ ,..,.. ._. . .
. . . . . . ,......
(jj) ~~~~~~~ ~~~~~:~~:.~~~
. ..a %.;;A...: .A.. i ./.
CENTER 134 000 000 MHZ SPAN 50 000 000 MHZ
Figure 2-30. Example Magnitude Response Measurement Results
Measuring Insertion Phase Response
7. To view both the magnitude and phase response of the device, as shown in Figure 2-31,
press:
The channel 2 portion of Figure 2-31 shows the insertion phase response of the device under
test. The analyzer measures and displays phase over the range of - MO0 to + 1800. As phase
changes beyond these values, a sharp 360° transition occurs in the displayed data.
CENTER 134 000 000 MHZ SPAN 50 000 000 MHZ
Figure 2-31. Example Insertion Phase Response Measurement
2-36 Making Measurements