HP 8753E - Page 15

3.
Set Up the Lower Stopband Parameters ..................
2-63
Set Up the Passband Parameters .....................
2-63
Set Up the Upper Stopband Parameters ..................
2-63
Calibrate and Measure
...........................
2-64
Measurements Using the Tuned Receiver Mode
................
2-66
Typical test setup
.............................
2-66
Tuned receiver mode in-depth description
..................
2-66
Frequency Range
............................
2-66
Compatible Sweep Types .........................
2-66
External Source Requirements ......................
2-67
Test Sequencing
...............................
2-68
Creating a Sequence
.............................
2-69
Running a Sequence
............................
2-70
Stopping a Sequence
............................
2-70
Editing a Sequence
............................
2-71
Deleting Commands ...........................
2-71
Inserting a Command ..........................
2-71
Modifying a Command ..........................
2-72
Clearing a Sequence from Memory
.....................
2-72
Changing the Sequence Title
........................
2-73
Naming Files Generated by a Sequence
....................
2-73
Storing a Sequence on a Disk
........................
2-74
Loading a Sequence from Disk
.......................
2-75
Purging a Sequence from Disk
.......................
2-75
Printing a Sequence
............................
2-75
Cascading Multiple Example Sequences
...................
2-76
Loop Counter Example Sequence
......................
2-77
Generating Files in a Loop Counter Example Sequence
............
2-78
Limit Test Example Sequence
........................
2-79
Measuring Swept Harmonics (Option 002 only)
................
2-81
Measuring a Device in the Time Domain (Option 010 only)
...........
2-83
Transmission Response in Time Domain
...................
2-83
Reflection Response in Time Domain
....................
2-88
Non-coaxial Measurements
..........................
2-91
Making Mixer Measurements
Where to Look for More Information
.....................
Measurement Considerations
.........................
Source and Load Mismatches
..................
Reducing the Effect of Spurious Responses
.................
EliminatingUnwantedMirringandLeakageSignals.
.............
HowRFandIFAreDefIned
........................
Frequency Offset Mode Operation
......................
Differences Between Internal and External R Channel Inputs
.........
Power Meter Calibration
..........................
Conversion Loss Using the Frequency Offset Mode
...............
High Dynamic Range Swept RF/IF Conversion Loss
..............
Fixed IF Mixer Measurements
........................
Tuned Receiver Mode
...........................
Sequence 1 Setup
.............................
Sequence 2 Setup
.............................
Phase or Group Delay Measurements
.....................
Amplitude and Phase Tracking
........................
Conversion Compression Using the Frequency Offset Mode
...........
Isolation Example Measurements
.......................
3-l
3-2
3-2
3-2
3-2
3-2
3-4
3-4
3-6
3-7
3-12
3-17
3-17
3-17
3-21
3-24
3-27
3-28
3-33