HP 8753E - Page 217

f. Press m and select one of the following:
::;,:p .‘);. .:<. .:’ .VB . . . . . . .:
,: ::
0 Choose ‘:~~~~~~~~ to allow the analyzer to control peripherals directly.
.: : .:...........:: ._.,.,.. _
0 Choose ~~~~~~~ to allow the computer controfler to be involved h a
:i:....... i.. ;.m..i ..::. .;:..z.:
.:
..., ,,,, .,w ..:.
peripheral access operations.
q Choose :~~~~~~~~ to allow yowself to control the analyzer Over HP-IB and also
:<!.:.<<<.. ..:e% ..,,,, .,.,~.::.:.:~.,~.,.,.,.:; .:...... . . ..a
allows the analyzer to take or pass control.
4. press (--) :~~:~~-~~~~~~~~~~ .
: 5 .: ;.:
1.: .,........ :..:..a
,...:::. :.<<.:.:.i.T . . . . . . . . . .
5. Define the save by selecting one of the following choices:
If you c&led ~~~~~~~~~~~~ ~~~~~.~~, or :~~~~, ~,~~'~~K. the data is d-red
,
,.;,.:..;: . . . . . . . . . T..
to disk in IEEE-64 bit real format (for LIF disks), and 32 bit PC format for DOS disks This
makes the DOS data illes half the size of the LIF files.
Note
~,l~ding ~~~~~~~~~~.~~:~, may store data to disk in the S2P ASCII data format.
,/ ,,.. . . . .:.; ,.,.,
. . . . . . . . /
See “ASCII Data Formats. ’
,.,.,.,.,.,.,.,.,.,.,.,. _ ,, _.,.,.,.,.,.,.,.,.,.,.; _.,. ._;
If you s&& ~~~~~~~~~ me use, gaptics wea is saved. (Refer to the
HP 87533 Network Aruzlgm Programmer’s G&de for information on using display
graphics.) The measurement display is not saved with this selection. (Refer to the
information located earlier in this chapter for a procedure that shows you how to plot
measurement displays to disk.)
Note
6. Choose the type of format you want:
,_ . .
;;.;::.- .<m _
q Choose ~~~~~~~~~~:~;~~~:~~~~ for all appfiations except, CIWile, S2P, or CAE applications.
q ’ Choose ~~~~~~~~~~~~~ for CITIfile, s2p, and cAE applications or when you want to
z: I,.;;;;;;; . . . . . . . . ..L ..+:.;; . . . . . . . . . . s.2;:: . . . . . . IL: ..__ .::.:::..i ..-.... i.
import the information into a spread sheet format.
4-36 Printing, Plotting, and Saving Measurement Results