HP 8753E - Page 254

4. ‘lb define the THRUAJNE standard, press:
5. To define the LINE/MATCH standard, press:
6. For the purposes of this example, change the name of the standard
;;;;...> .;..:.. x;;..;,. ‘;I- c. Ti. ~,.z,.<~‘:e 5 p “‘p <y :;;;..
by pressing ‘$@&&&f&$ ~~~~~~~~~:: if a previous title exiSts,
. . . . . . . . ,/ . . . . . ../...................... %.,:I . . . . . . . . . ..A.. .A.>> . ..A .;;.......~.;~:....~.i .:: ~:::...m.= i :;:.:::... ’
and then modify the name to “MATCH”.
7. When the title area shows the new label, press:
Assign the Stadards to the Various TRM Classes
8. To assign the calibration standards to the various TRL calibration classes, press:
9.
Since you previously designated standard #l for the REFLECT standard, press:
mil
10. Since you previously designated standard #3 for the LINE/MATCH standard, press:
:~~~~~~~;~~~~ @ (Xl)
,.,<.~...S.. ,,...:...... i;;;;;,;...~~~~............................~.~.~.~.~.~.~.~ .._..........
,........................
11. Since you previously designated standard #4 for the THRWLINE standard, press:
12. To complete the specification of class assignments, press:
6-32 Optimizing Measurement Results