HP 8753E - Page 366

Detie Standard Menus
Standard dellnition is the process of mathematically modeling the electrical characteristics
(delay, attenuation, and impedance) of each calibration standard. These electrical
characteristics (coefficients) can be mathematically derived from the physical dimensions and
material of each calibration standard, or from its actual measured response. The parameters of
the standards can be listed in lhble 6-5.
TIhble 6-5. Standard DelInitions
System %a =
Disk F’ile Name:
Calibration Kit Label:
-r
STND
LABEL
aEnsure system ZQ of network analyzer is set to this value.
bOpen, short, load, delay/thru, or arbitrary impedance.
%oad or arbitrary impedance only.
dArbitrary impedance only, device terminating impedance.
‘Open standard types only.
Application and Operation Concepts 6-66