HP 8753E - Page 685

l&J, 6-51
It), 6-11
@J], 6-78
0, 6-11
@jiiJ, 6-42
entry, 6-9-l 1
WK l
instAent state, 6-110-116
&iJ, 6-111
B ;2$ 6-30
Menu ,
- ,.a-
WI, o-11
response function, 6-28-53
step, 6-10
stimulus function, 6-12-27
&iGY], 6-117
units terminator, 6-10
($J 0, 6-10
key to HP-IB command, 9-54
kit label, 5-31, 5-33
knob
RPG, 6-10
L
label class menu, 6-91
label kit, 5-31, 5-33
menu, 6-91
label the classes, 5-31, 5-33
LCD, 1-7
LEO (no extended listener capabilities), 11-19
LIF format, 11-5
limit lines, 6-114
limits
editing, 6-l 15
offset, 6-116
limit segments
editing, 6-l 15
limit test
connector location, 1-12
example sequence, 2-79
limit testing, 2-46
activating, 2-53
creating flat Iimit lines, 2-47
creating single point limits, 2-51
creating sloping limit lines, 2-49
deleting limit segments, 2-52
editing Iimit segments, 2-52
offsetting limit lines, 2-54
pass/fail indicators, 2-54
reviewing Iimit Iine segments, 2-53
running a limit test, 2-53
sequencing, 2-79
iimit test output (LIMIT TEST), 7-18
linear
phase deviation measurement, 2-42
linear frequency sweep, 6-22
linear magnitude format, 6-36
line power,
7-19
lines for control, 11-17
lines for handshaking, 11-17
line types
plotter, 4-14
line types available, 4-14
line voltage selector switch, l-11
LIN MKR, 2-25, 2-26
listener interface function, 11-16
listen mode (L), 11-20
list frequency sweep
increasing sweep speed, 5-50
making measurements, 2-61
list values
printing or plotting, 4-30
L (listen mode), 11-20
loading a sequence from disk, 2-75
load match, 6-59
uncorrected specifications, 7-3
m key, 6-111
m menu map, 8-7
location
10 MHz precision reference output, l-11
10 MHz reference adjust, l-11
analyzer display, l-4
auxihary input connector, 1-12
bias inputs and fuses, 1-12
centronics (parallel) interface, l-l 1
disk drive, l-4
entry block, l-4
external trigger connector, 1-12
fan, l-11
fuse, l-11
limit test connector, 1-12
line switch, l-4
line voltage selector switch l- 11
p1 Md p2 h ~~~~~~~~~~~~~~: mode,
4-15
parallel (centronics) interface, l-11
pass/fail message, l-10
port 1 and port 2, l-6
preset key, l-6
probe power source connector, l-6
R channel connectors, l-6
response function block, 14
RS-232 (serial) interface, l-11
serial number plate, 1-12
serial (RS-232) interface, l-11
Index-12