HP 8753E - Page 692

configuring a print function, 4-3
constructing a loop structure in a sequence,
2-77
coupling and uncoupling display markers,
2-24
creating a sequence, 2-69
creating flat limit lines, 2-47
creating single point limits, 2-51
creating sloping limit lines, 2-49
defining line types, 4-14
defining the plot, 4-12
de&ring the print, 4-5
deleting an instrument state, 4-41
deleting a single instrument state fle, 4-41
deleting limiting segments, 2-52
deviation from linear phase measurement,
242
dividing measurement data by the memory
trace, 2-8
editing a sequence, 2-71
editing limit segments, 2-52
entering the power sensor calibration data,
5-35
error-correction for full two-port
measurements, 5-2 1
error-correction for one-port reflection
measurements, 5-18
error-correction for TRL*, 5-24
error-correction for TRM+, 5-24
formatting a disk, 4-43
frequency response error-corrections, 5-9
gating in time domain, 2-85
inserting a sequence command, 2-71
limit testing using a sequence, 2-79
loading a sequence from disk, 2-75
making accurate measurements of
electrically long devices, 5-48
measuring devices using the time domain,
2-83
measuring electrical length and phase
distortion, 2-40
measuring gain compression, 2-55
measuring group delay, 243
measuring magnitude and insertion phase
response, 2-37
measuring reflection response in time
domain, 2-88
measuring reverse isolation and gain, 2-59
measuring swept harmonics, 2-81
measuring transmission response in time
domain, 2-83
mixer group delay or phase, 3-24
modifying a sequence command, 2-72
modifying calibration standards, 5-27
modifying TRL calibration standards, 5-29
modifying TRMM calibration standards,
5-31
offsetting limit lines, 2-54
outputting a single page of values, 4-30
outputting multiple plots to a single page
using a printer, 4-25
outputting plot flies, 4-20
outputting plot files from a PC to a plotter,
4-22
outputting plot files from a PC to a printer,
4-23
outputting single page plots using a printer,
4-24
outputting the entire list of values, 4-31
plotting a measurement to disk, 4-19
plotting measurements in page quadrants,
4-28
plotting multiple measurements on a full
page, 4-26
plotting multiple measurements per page,
4-17, 4-26
plotting to an HPGL compatible printer,
4-18
printing a sequence, 2-75
printing multiple measurements per page,
4-7
printing one measurement per page, 4-6,
4-16
printing or plotting list values or operating
parameters, 4-30
purging a sequence from disk, 2-75
ratioing measurements in channel 1 and
2, 2-8
recalling a file, 4-42
renaming an instrument state file, 442
re-saving an instrument state, 4-41
resetting plotting parameters to default
values, 4-16
resetting the printing parameters to default
values, 4-6
response and isolation error-correction for
reflection measurements, 5-14
response and isolation error-correction for
transmission measurements, 5-16
response error-correction for reflection
measurements, 5-9
response error-correction for transmission
measurements, 5-l 1
reviewing limit line segments, 2-53
running a limit test, 2-53
nmning a sequence, 2-70
saving a data trace to the display memory,
2-7
saving an instrument state, 4-35
searching for a target amplitude, 2-34
Index-l 9