HP 8753E - Page 694

level of display, l-10
markers, 2-20
reference documents, 6-171
reference plane
extending, 5-3
reflection measurements
using bandpass mode, 6-127
using low pass mode, 6-131
reflection response in time domain, 2-88
reflection tracking
uncorrected specifications, 7-3
register
contents, 4-33
register data
retention, 4-33
Re/Im MKR, 2-25, 2-26
relative
marker mode, 2-20
relative velocity factor
adjusting of, 6-127
relative velocity for time domain, 2-90
remote control, 11-15
remote enable (REN) control line, 11-18
remote/IocaI capability (RLl), 11-19
remote operation (R), 11-20
remote programming speciiications, 7-17
renaming a fiIe, 4-42
REN (remote enable) control line, 11-18
repeatability
connector, 5-2
repetitive attenuator switching
allowing, 6-20
re-save a file, 4-41
reset
plotting parameters to default values, 4-16
printing parameters, 4-6
resolution
time domain, 6-139
response
calibration connections, 3-18, 3-34, 3-36
error-correction for reflection
measurements, 5-9
error-correction for transmission
measurements, 5-l 1
function block location, l-4
response and isolation calibration, 6-80
response calibration, 6-80
response function, 6-28-53
restarting a calibration, 6-82
results of measurement
saving, 4-36
retention
of memory data, 433
reverse isolation and gain measurement,
2-59
reviewing the Iimit Iine segments, 2-53
RF
how defined for mixers, 3-2
RF feedthrough, 3-35
R+jX MKR, 2-26
RLl (complete remote/local capability), 11-19
RPG knob, 6-10
R (remote operation), 11-20
RS-232 (serial) interface, l-11
rules for code naming, 11-22
running
a Iimit test, 2-53
a sequence, 2-70
S
S2P ASCII data format, 4-39
sample-and-sweep correction mode, 5-37
sample-and-sweep mode
for power meter calibration, 5-37
sampler/IF correction, 6-5
save a data trace to the display memory, 2-7
($Z&ZiJ menu map, 8-11
saving
a file, 4-33
a user kit, 5-29
places where you can, 4-33
to a computer, 4-34
user kit to disk, 5-29
saving measurement results including
calibration, 4-36
saving, printing, and plotting, 4-l
scale, 6-7
s@e&liv. area of display, l-10
. . . . .. . . . . . . . ill ,,
~~~~~~~~~,, 4-15
scale reference menu, 641
@JZZ) menu map, 8-12
searching for values with markers, 2-32
bandwidth, 2-35
maximum amplitude, 2-32
minimum amplitude, 2-33
target amplitude, 2-34
tracking amplitude, 2-35
second portion of conversion compression
measurement connections, 3-30
segment
deleting, 2-52
segment menu, 6-23
selecting
calibration kits, 6-82
selecting Iine types, 4-14
sensor calibration data, 5-35
(TJ menu map, 8-13
sequence
creation, 2-69
size of, 6-147
Index-21