HP 9000 Series Service Manual

Chapter 5 5-17
Dx50/Dx60 Front Panel LCD Codes
FLT 7304 Unknown sizing compare fault
FLT 7305 Multi-bit error occurred during sizing
FLT 7306 Address test failed on memory bank
FLT 7307 ECC test failed on memory bank
FLT 7308 Single bit memory error caused HPMC
FLT 7401 No memory SIMMs installed
FLT 7402 Both EDO and STD memory SIMMs installed
FLT 7403 Address did not map to bank
FLT 7404 Address did not map to Group Configuration Table
FLT 7405 Dual issue test failed
FLT 7500 No RAM found
FLT 7501 Not enough good memory to run Operating System
FLT 7502 Not enough good memory to run Boot Console Handler
FLT 7604 No bits set in memory test status
WARN 7701 Using alternate memory configuration
WARN 7702 Memory not tested, initialized only
WARN 7703 SIMM loading warning
WARN 7704 RAM bus warning
WARN 7705 Good memory required to run Operating System is greater than memory
size
WARN 770F Rev 1 Slave Memory Controller search routine being used
WARN 7800 PDT disabled warning
FLT 7800 PDT disabled halt
WARN 7801 Overwrite single bit error with multi-bit error in Page Deallocation Table
WARN 7802 Duplicate Page Deallocation Table entry
WARN 7803 EEPROM fault while updating Page Deallocation Table
WARN 7804 Page Deallocation Table is full
PDCE_HPMC Memory Fault Codes
FLT 7D03 MSI read time-out (HPMC, caused by accessing beyond the end of memory
or non-responding Slave Memory Controllers)
FLT 7D04 MSI write time-out (HPMC, caused by accessing beyond the end of memory
or non-responding Slave Memory Controllers)
Ostat Code Description

HP 9000 Series Specifications

General

Operating System	HP-UX
Manufacturer	Hewlett-Packard (HP)
Series	9000
Type	Server
Processor	PA-RISC
Memory	Varies by model
CPU	PA-RISC processors
Expansion Slots	Varies by model
Networking	Ethernet
Form Factor	Rackmount
Models	A-Class, D-Class, E-Class, K-Class, N-Class, RP Series, Superdome