HP 9000 Series Service Manual

5-32 Chapter 5
Dx50/Dx60 Front Panel LCD Codes
Memory SIMMs are not installed in the proper sequence. The Boot
command has been disabled to prevent thermal damage. Refer to the
memory configuration label for proper sequence.
Memory has been reconfigured due to a physical change or because the
Page Deallocation Table (PDT) was cleared. This is for information
only. No action is required.
Memory banks deallocated due to a SIMM size mismatch or a SIMM
failure. Refer to the ME command in the INFORMATION menu for error
information.

HP 9000 Series Specifications

General

Operating System	HP-UX
Manufacturer	Hewlett-Packard (HP)
Series	9000
Type	Server
Processor	PA-RISC
Memory	Varies by model
CPU	PA-RISC processors
Expansion Slots	Varies by model
Networking	Ethernet
Form Factor	Rackmount
Models	A-Class, D-Class, E-Class, K-Class, N-Class, RP Series, Superdome