HP 9000 Series Service Manual

Chapter 12 12-7
Remote Management/Access Port Card
Mn n=0 to 3
M0 means monitor speaker always off.
***M1 means monitor on until carrier detected.
M2 means monitor always on.
M3 means monitor on during dialing, off during
handshaking.
$MBn n=speeds
$MB75 selects CCITT V.23 mode.
$MB300 selects 300 bps on-line.
$MB1200 selects 1200 bps on-line.
$MB2400 selects 2400 bps on-line.
$MB4800 selects 4800 bps on-line.
$MB9600 selects 9600 bps on-line.
***$MB14400 selects 14400 bps on-line.
O Exit command mode and go into on-line mode.
P (not
applicable in
Denmark)
***Modem will pulse dial numbers following the P.
&Pn (Not
applicable in
the U.K.)
n=0 or 1
***&P0 means 60-40 pulse ratio.
&P1 means 67-33 pulse ratio.
Qn n=0 to 2
***Q0 means result codes sent.
Q1 means result codes will be suppressed (quiet).
Q2 means dumb answer mode.
&Qn n=0 or 1
***&Q0 selects Multi-Tech command set.
&Q1 selects AT command set.
Rn n=0 or 1
***R0 means modem will not reverse modes.
R1 means modem will reverse modes.
&Rn n=0 to 2
***&R0 lets clear to send act normally.
&R1 forces clear to send on.
&R2 drops 2 seconds on disconnect
$Rn n=0 or 1
$R0 means disconnect after 12 retransmits.
$R1 means do not disconnect after 12 retransmits.
&RFn n=0 or 1
&RF0 selects CTS follows RTS
***&RF1 selects CTS to act independently.
Command Values Description

HP 9000 Series Specifications

General

Operating System	HP-UX
Manufacturer	Hewlett-Packard (HP)
Series	9000
Type	Server
Processor	PA-RISC
Memory	Varies by model
CPU	PA-RISC processors
Expansion Slots	Varies by model
Networking	Ethernet
Form Factor	Rackmount
Models	A-Class, D-Class, E-Class, K-Class, N-Class, RP Series, Superdome