103
Other criteria
NOTE:
The A5120 EI Switch Series supports port-based VLAN, MAC-based VLAN, protocol-based VLAN, and IP-based
VLAN. The port-based VLAN implementation is the basis of all other VLAN implementations. To use any other
VLAN implementations, you must configure port-based VLAN settings.
You can configure all these types of VLANs on a port at the same time. When the switch is determining which
VLAN a packet that passes through the port should be assigned to, it looks up the VLANs in the default order of
MAC-based VLAN, IP-based VLAN, protocol-based VLAN, and port-based VLAN.
Configuring basic VLAN settings
Follow these steps to configure basic VLAN settings:
vlan { vlan-id1 [ to vlan-id2 ] |
all }
Optional
Use this command to create VLANs in
bulk.
Required
If the specified VLAN does not exist, this
command creates the VLAN first.
By default, only the default VLAN (VLAN
1) exists in the system.
Configure a name for the
current VLAN
Optional
By default, the name of a VLAN is its
VLAN ID (VLAN 0001, for example).
Configure the description of
the current VLAN
Optional
VLAN ID is used by default (VLAN 0001,
for example).
NOTE:
As the default VLAN, VLAN 1 cannot be created or removed.
You cannot manually create or remove VLANs reserved for special purposes.
You cannot remove dynamic VLANs by using the undo vlan command.
You cannot remove a VLAN with a QoS policy applied.
After associating an isolate-user-VLAN with a secondary VLAN, you cannot add ports to, remove ports from, or
remove the VLANs. To do that, remove the association first.
You cannot remove a VLAN that is operating as a probe VLAN for remote port mirroring, or an RRPP-protected
VLAN by using the undo vlan command. To do that, remove the remote probe VLAN or RRPP-protected VLAN
configuration from it first.
To Next Page
Loading...
Need help?
General
