HP A5120 EI Series

106
Port type
Actions (in the inbound direction)
Actions (in the outbound
direction)
Untagged frame
Tagged frame
Hybrid
Send the frame if its VLAN is
carried on the port. The frame
is sent with the VLAN tag
removed or intact depending
on your configuration via the
port hybrid vlan command.
This is true of the PVID.
Assigning an access port to a VLAN
You can assign an access port to a VLAN in VLAN view, interface view (including Ethernet interface view
and Layer 2 aggregate interface view), or port group view.
Follow these steps to assign one or multiple access ports to a VLAN in VLAN view:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter VLAN view
vlan vlan-id
Required
If the specified VLAN does not exist, this
command creates the VLAN first.
Assign one or a group of access
ports to the current VLAN
port interface-list
Required
By default, all ports belong to VLAN 1.
Follow these steps to assign an access port (in interface view) or multiple access ports (in port group
view) to a VLAN:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter interface
view (including
Ethernet interface
view, Layer 2
aggregate
interface view) or
port group view
Enter Ethernet
interface view
interface interface-type
interface-number
Required
Use either command.
 In Ethernet interface view, the
subsequent configurations
apply to the current port.
 In port group view, the
subsequent configurations
apply to all ports in the port
group.
 In Layer 2 aggregate interface
view, the subsequent
configurations apply to the
Layer 2 aggregate interface
and all its member ports.
Enter Layer 2
aggregate
interface view
interface bridge-aggregation
interface-number
Enter port
group view
port-group manual port-group-
name
Configure the link type of the port or
ports as access
port link-type access
Optional
The link type of a port is access
by default.