EasyManuals Logo

HP A5120 EI Series Configuration Guide

HP A5120 EI Series
197 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #48 background imageLoading...
Page #48 background image
41
Any two or all three of these elements ingress port number, source MAC address, and destination
MAC address
Configuring group-specific load-sharing criteria
Follow these steps to configure load-sharing criteria for a link aggregation group:
To do…
Use the command…
Remarks
Enter system view
system-view
Enter aggregate interface
view
interface bridge-aggregation
interface-number
Configure the load-sharing
criteria for the aggregation
group
link-aggregation load-sharing mode
{ destination-ip | destination-mac |
source-ip | source-mac } *
Required
By default, an aggregation group
uses the global link-aggregation
load-sharing criteria.
You can set the following group-specific load-sharing criteria:
Source IP address
Destination IP address
Source IP address and destination IP address
Source MAC address
Destination MAC address
Destination MAC address and source MAC address
CAUTION:
By default, an aggregation group uses the global link-aggregation load sharing criteria. You can
configure the group-specific link-aggregation load-sharing criteria to overwrite the global ones, except
those specified with the destination-port, source-port, or ingress-port keywords.
Enabling local-first load sharing for link aggregation
Use the local-first load sharing mechanism in a cross-switch link aggregation scenario to distribute traffic
preferentially across all member ports on the ingress switch rather than all member ports.
When you aggregate ports on different member switches in an IRF fabric, you can use local-first load
sharing to reduce traffic on IRF links, as shown in Figure 10. For more information about IRF, see the IRF
Configuration Guide.

Table of Contents

Other manuals for HP A5120 EI Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP A5120 EI Series and is the answer not in the manual?

HP A5120 EI Series Specifications

General IconGeneral
Uplink Ports4 x SFP
StackingNo
ManagementCLI, Web, SNMP
Routing ProtocolsRIP, OSPF
Power SupplyAC
MAC Address Table Size16K
Dimensions440 x 430 x 44 mm
Operating Temperature0°C to 45°C
Operating Humidity10% to 90% non-condensing
ModelHP A5120-24G EI Switch (JG234A)
VLANs4094

Related product manuals